Residue-free carpet cleaning in Logan, UT

Carpet that gets dirty again a few weeks after a cleaning usually has one problem: something sticky stayed in the pile. We clean in a way that leaves little behind, so your carpet feels softer and holds new dirt off longer.

ACDC is family-owned and has cleaned carpet in Logan since 2010. The owner is on most every job.

Call (435) 554-8383.

Dirt is not the only thing that can stay in carpet. Cleaner can stay too. If soap or cleaner is not fully rinsed out, it leaves a thin film on the fibers. That film is sticky. Shoes, pets, and dust stick to it, and the carpet looks dirty again fast. It can also feel stiff.

Foot traffic dirties any carpet over time. The goal is that the cleaning itself does not speed that up.

We use four steps, in this order:

1. Soft water. We start with soft water so the cleaner rinses out cleanly.
2. A properly diluted cleaner. More cleaner is not better. Mixed to the right strength, there is less to rinse out later.
3. Thorough extraction. What does not get pulled out stays in the carpet.
4. A neutralizing rinse. The last pass neutralizes what is left of the cleaner, so nothing sticky stays in the pile.

Good question, and we hear it a lot. Zerorez uses a special alkaline water that cleans without adding soaps. We get to the same low-residue result a different way: soft water, a properly diluted cleaner, thorough extraction, and a neutralizing rinse.

The difference is the chemistry and the steps, not the brand. When the steps are done right, carpets stay softer and get dirty again more slowly either way. If you are comparing two companies, ask each one how they keep residue out of the carpet. Then pick the one you trust.

For short answers on soap residue, soft water, and the rinse, see our FAQ.